top of page
MIMESIS 37S NEXTGEN
Preamplifier
goldmund audio mimesis 37S nextgen

Goldmund Mimesis 37S NextGen is a high-end analog stereo preamplifier. Its ability to reduce noise and distortion using multiple parallel preamplifier stages is purely incredible. A Full Dual-Mono construction with processor-driven linked attenuators, the Mimesis 37S NextGen uses a separate power supply unit for optimum noise reduction and 2 successive stages of power regulation with 4 separate circuits.

goldmund audio mimesis 37S Nextgen
SPECIFICATIONS

INPUTS

    Input impedance: 39 kOhms.
    Maximum input level (balanced): 9.6 Vrms.
    Maximum input level (unbalanced): 4.8 Vrms.
    Separated input level adjustment for each of the 7 line inputs: -12 to +12 dB.

OUTPUTS

    Output impedance: 50 Ohms.
    Maximum output level (balanced): 19.2 Vrms.
    Maximum output level (unbalanced): 9.6 Vrms.

FREQUENCY RESPONSE
These values for any level to maximum output level.

    +/- 0 dB, 20 – 20 kHz.
    +/- 3 dB, 0.2 – 900 kHz.

GROUP DELAY

    Propagation delay <300 ns stable with frequency from DC to 200 kHz.

SPEED

    Slew rate of the amplification stages: 200 V/us.
    Rise time: < 400 ns.

CROSSTALK

    Separation: > 105 dB between channels (20 Hz – 20 kHz).


DISTORTION


With 1 Vrms output level, 80 KHz measurement bandwidth, 600 ohms termination impedance.

    THD unbalanced input to unbalanced output: 0.002 % flat with frequency.
    THD balanced input to balanced out: 0.001 % flat with frequency.
    IMD unbalanced input to unbalanced output: 0.002 %.
    IMD balanced input to balanced out: 0.001 %.

NOISE

    Signal-to-noise ratio on line input: > 120 dB (0.01 Hz – 10 Mhz).
    Weighted ASA A: > 130 dB.

OPERATING TEMPERATURE

    Room temperature: -30 to +40 degrees Celsius.
    Internal temperature: +45 to +70 degrees Celsius.

POWER

    Nominal line voltage: 115 or 230 V.
    Input voltage range: +/-15 %.
    Maximum power consumption: 70 W.

GROUNDING

    Separated ground and earth signal.

SAFETY FEATURES

    Automatic switching to MUTING if the AC line drops or is interrupted.
    Automatic protection against tape loops.

FRONT PANEL

    VOLUME control.
    BALANCE control.

REAR PANEL

    Power connector.
    Output connectors RCA (right and left).
    Output connectors RCA (right and left) for Tape 1 and Tape 2.
    Input connectors RCA (right and left) for Tape and line inputs.

POWER SUPPLY CONTROLS

    Power cord socket (3 lugs).
    Main fuse (2.5 A slow-blow).
    Voltage selector 115/230 V.
    Earthing post (yellow-green).

SIZE & WEIGHT
PREAMPLIFIER:

    44 W x 13.5 H x 40 D (cm) – 17.3 W x 5.12 H x 15.75 D (inch) without power cord.
    9 kg.

POWER SUPPLY:

    44 W x 13.5 H x 38.5 D (cm) – 17.3 W x 5.12 H x 14.96 D (inch), without power cord.
    12 kg.

WARRANTY

    3 years, parts and labor (except drivers).

bottom of page